View Single Post
Unread 12-16-2022, 10:58 AM   #17
Member
Dean Romig
PGCA Invincible
Life Member
 
Dean Romig's Avatar

Member Info
 
Join Date: Dec 2008
Posts: 31,562
Thanks: 35,442
Thanked 33,042 Times in 12,322 Posts

Default

Art touches on some very important points and gives very good advice.

I would FIRST make sure you have a good set of gunsmithing turnscrews (screwdrivers) and proceed with caution while applying firm even pressure as you try to break the screws free. Make sure the screw slots are clean and free of crud!!

My trick for a stuck in the wood trigger guard strap or tang is, after the screws are removed and the tang won't lift from the channel in the wood because of hardened 100-year-old crud, don't try to lift it or you may chip or splinter the wood...
Instead, rap the rear of the trigger guard bow firmly in in a motion that will drive it forward. It should break free pretty easily after just one or two firm raps and will lift up with no damage to the wood at all. Then rotate the trigger guard in a counter-clockwise motion. If it will not rotate freely it will need some solvent on the threaded area. Attempting to force it will only result in a bent and distorted trigger guard and they're an absolute bitch to straighten them back to the correct shape and angle... ask me how I know...





.
__________________
"I'm a Setter man.
Not because I think they're better than the other breeds,
but because I'm a romantic - stuck on tradition - and to me, a Setter just "belongs" in the grouse picture."

George King, "That's Ruff", 2010 - a timeless classic.
Dean Romig is offline   Reply With Quote
The Following User Says Thank You to Dean Romig For Your Post: