Shotgun in hand:
Most of the advertised descriptions were correct. The bores are better than expected, no worries about wall thickness or previous honing. Sometimes you get a gun and the only things you can do are clean the bores, oil the metal and wipe down the wood. I can’t think of any reasons to try and improve this one. Edit: I did clean up the rusty skeleton butt plate, however gently with Hoppes and oil, no buffing. When I get some 2-5/8” brass 10 gauge shells this heavy gun will get a workout. At over ten pounds, recoil will be tame with square one ounce loads.
The grip cap is definitely steel and some of the plating remains (cap screw too), nickel or silver. I will share the PGCA letter when it arrives. I’m hoping for a good one.
One aspect I haven’t mentioned, the size of the butt stock is much larger than my 1-1/2 frame 12 gauge. It’s way taller and wider, a taste of what the 8 gauge guys shoulder.
Last edited by Bruce P Bruner; 07-30-2022 at 07:48 PM..
Reason: Butt plate photo
|