Quote:
Originally Posted by Jerry Harlow
Whats wrong with the sizer on the 600 Jr.? It does a decent job.
If you want a .410 Super Sizer find a used 12 which are relatively cheap and buy the conversion kit. I found a couple for $25 each and did that to them.
|
the issue is - especially in older guns - chambers vary -
I had a 10 gauge guun that I had to run the shells fired in it through a super sizer before they would fit in the Jr. Another 10 was tight but would fit into the JR. Shells fired in my Ithaca Super 10 barely cause any resistance in the resizer on the Jr