Thread: Frame Sizes....
View Single Post
Unread 01-04-2013, 12:08 AM   #1
Member
David Noble
PGCA Member
 
David Noble's Avatar

Member Info
 
Join Date: Nov 2010
Posts: 1,012
Thanks: 1,651
Thanked 1,246 Times in 447 Posts

Default

I have mentioned before, and I'm sure raised a few eye browses in doing so, but in the mid to late eighties I had a damascus 8ga CH gun with 36 inch barrels come into my gun store. This was the most massive Parker I had ever seen and though I didn't actually weigh it, it honestly felt like a twenty pound gun. The stock was just as massive overall however I do not recall it being excessively long but my fingers would not wrap fully around the thick grip area. Here is the part that draws skepticism when I relate the story. On the barrel lug, where the frame size was stamped on these guns, was a very defined number 8 stamped. At the time I assumed it was referring to the gauge, which I knew to be an 8 ga. Reflecting back, and to my knowledge the gauge was not stamped on these early hammerless guns and there were no other numbers on the lug. Unfortunately I did not record the serial number of the gun. It was not in my possession long as the gun was stolen and I knew it was being brought in and had called the police ahead of time. It turned out to have been stolen from a Judge who lived outside of the Dallas Ft. Worth area. Be skeptical if you must, but I know what I saw.
David Noble is offline   Reply With Quote
The Following 4 Users Say Thank You to David Noble For Your Post: