Eldon, I am happy to help. Ya know, I should have qualified my earlier statement about Ithaca and Fox hinge pins. I know for a fact that A H Fox and Ithaca NID hinge pins are dead straight because I've rejointed a few of each. HOWEVER, I've never done the earlier Ithaca Flues model and for all I know its hinge pin is tapered. Any Syracuse Arms enthusists out there? SAC used tapered hinge pins and are a challenge to get back on the face because of that design. I did one SAC gun and all I have to say is, never again. Possibly the best way to do that is press out the old pin, fixture the barrels so they are dead on the face + a little bit for wearing in, then line-bore/ream on the mill for an oversize straight or tapered pin. Of course the new pin will have to be dressed off on the sides of the frame which would be very difficult without marring the frame colors on both sides. Just thinking out loud..... Good luck with your project.
|