Naw, a 1/2" should be ok. Don't put much pressure - go lightly. It's a feel type of operation. The spinning tool has to heat the material and then it will roll over. I find it's easier with a small drill press to keep the top even and parallel with the side, but it can be done with a hand drill. Just thought - don't use any crimp station with the press if you have the tool that spins. You just deprime, prime, add powder, then the wads, next shot and a over shot card, then remove it from the press. Use your hand spinner to do all the crimp operation. Should come out nice.
__________________
Paul Harm
|