View Single Post
Unread 06-11-2012, 04:18 PM   #12
Member
Pa SxS
Research Chairman
PGCA Lifetime
Member
 
Chuck Bishop's Avatar

Member Info
 
Join Date: Nov 2008
Posts: 2,983
Thanks: 1,272
Thanked 5,311 Times in 1,507 Posts

Default

I'm going to add some extra info I found while learning to read the stock books.

Many times the order book will specify how the customer wants the barrels choked. The stock book always recorded patterning information but unfortunately it's at the far right of the page and quite often much of the information is not there, it's cut off.

What I found on the very early S/N guns (1500 to 3900 in stock book # 1) was that both 10 and 12ga guns were patterened with #8 shot, 45yds, and a 18x24 target. I don't know if the target was a rectangle or an oval but all the patterning info that is readable, all used these specs. At about S/N 3950, you start to see 18x24 along with just 24 (with a circle around it.) Shortly there after, all patterning was done for both 10 and 12ga using #8 shot in a 24" circle at 45yards. Years later, it changed to 40 yards in a 30" circle.

Sometimes in the order book the customer will specify what brand of shot to use and also the size. I haven't correlated the order book with the stock book yet.

I'll add more confusion to this topic. In the 1882 catalog, it lists "Comparative Sizes of Drop Shot" table. There were 9 different manufacturers of drop shot listed along with the number of pellets to the ounce. Tatham shot was often used by Parker, they had 399 pellets of #8 shot to the ounce. The range of all manufactures was 365 on the low end to 434 on the high end. Kind of makes figuring out your chokes difficult if you don't know who made the shot. No standards back in those days.
Chuck Bishop is offline   Reply With Quote
The Following 3 Users Say Thank You to Chuck Bishop For Your Post: