Thread: DH new project
View Single Post
Unread 01-22-2012, 08:51 PM   #7
Member
John Hancock
Forum Associate

Member Info
 
Join Date: Oct 2011
Posts: 62
Thanks: 0
Thanked 81 Times in 23 Posts

Default

Bill, The plate was broke when I bought the action. I'll bet someone didn't take the top tang screw out and tried to pry off the trigger plate. Broke through the little hole that the trigger lift spring screw goes in. Will cut it off in front of the screw hole and cut one from another plate and weld on, thus saving the origional plate with the engraving matching the action. Got the release lever but no forend, get it all together have a local gun that can engrave the forend iron to match D grade engraving. Just need time and energy. Regards, John Hancock
John Hancock is offline   Reply With Quote