View Single Post
Unread 01-19-2012, 09:25 PM   #4
Member
J. A. EARLY
PGCA Member
 
Jerry Harlow's Avatar

Member Info
 
Join Date: Nov 2010
Posts: 2,112
Thanks: 4,580
Thanked 3,025 Times in 975 Posts

Default

Bill,

All of the hardware for the sling swivels was gone, they were not original anyway and the stock hole was drilled incorrectly just a fraction of an inch below the initial oval, so I only had three holes which were filled.

I sent the engraving work to Thierry Duguet. He does incredible work. It would not make sense to have this gun completely reengraved so Thierry just did the dogs, grass around the dogs, Parker Bros. and the forend latch since that had been buffed so much.

Check out his work: http://www.engraver.net/index.html
Jerry Harlow is offline   Reply With Quote