Hello Randy ,I was looking over this thread about 1:00 AM this morning and was just too tired to sit and type ,but I agree with Brian ,I too thought the gun may have been restocked and the checking isn't correct as Brian says , If you are careful not to bugger the Trigger guard screw ,you could take the screw out and lift the rear of the guard carefully not to chip any wood ," Don't pry with screw driver " and with the gun laying on its barrels ,turn the trigger guard counter clockwise , it will unscrew from the receiver and if it is the original stock ,the serial # will be stamped into the wood under the trigger guard , of course it is up to you if you want to check ,but I didn't know if you were aware of this ! Best ; Russ
|