Got the stock duplication done. I just used the pattern for my #2 frame trojan. I checked the inletting and fit against the original G stock and it was pretty darn close. So I figured that since the dimensions of the Trojan pattern were perfect for me, I would just use that one and save myself the time of setting up the original G stock on the duplicator. Plus the original stock was a bit short for my liking.
After it was done, I just removed the little bit on the bottom form the pistol grip and I was all set. The pictures show it after most of the machine lines were rasped out of the butt area. I put some alcohol on it to better show the color.
And since the my pattern had the proper curve to the back of it, all I will have to do is inlet for the spur at the top of the buttplate.
100_8949.jpg
100_8950.jpg
100_8951.jpg