[Roundsworth]

Harry, my outfit is not very sophisticated! I found a near-mint Lee hand tool for the 2-7/8" shell and will be using my new Hornady Lock and Load powder dispenser. The Hornady measure is a Godsend for all of my rifle loading. I have dippers for shot, also. Finally, I have a repaired 'roller' that does a swell job on paper and plastic hulls, should I decide to use a rolled crimp. It delivers a nice rounded roll-over. I have discovered with the pre-determined charge rotors for my RCBS Little Dandy that they fall short of their assigned charges of Unique by almost 1/2 grain. I did a lot of averaging and made notes about each rotor. I suppose volume charging is fine with less-than-maximum charges.