Quote:
Originally Posted by Jerry Harlow
Bill,
If it is nailed on as the originals were to be installed, wouldn't there be no holes in the back of the pad? I am betting that if a screwdriver of the proper size is sent down into the two holes, one will find screws holding it on. I could be wrong, but cannot find any other reason for the two holes in the original pad.
|
Bill is correct--These type pads are tacked & glued on. Click on the picture of the pad that researcher posted about them. The information in the text talks about the glueing & tacking method for installation.
I remember seeing some threads about these before, where the sponge rubber had to be cut through to remove the pad part just to reveal the tacks so the rest of the pad could be removed. I suspect that the holes in this pad were put there somewhere during this gun's life after the fact or whoever installed it decided two screws were an easier way to install it.
If only these guns could talk & tell us their story!