Quote:
Originally Posted by ScottPestell
Will the following load work in a Chedite hull using just fibre wads. Be using nitro wad, fibre wads for filler and over shot card.Will be used in a Remington 1882 10ga with fluid steel barrels.
Federal Hull, cut to 2 7/8", Wind 209 or Fiocchi 616 primer, 19 grain Red Dot, Remington SP10 Wad, 1/2 inch fiber filler wad, 6 point folded crimp.
|
2 7/8" hull, Cheddite or Win 209 primers, SP10 wad and a 1/2" filler inside that SP should work. I use Unique powder and a 16g 1/2" fiber wad for filler in the SP10 and 1 1/4 oz shot on top. You may need an OSC if your crimp doesn't close all the way.
Your nitro card and fiber wad recipe would work and should give you lower pressures. You might have to use hard fiber wads. You'll need to experiment with your wad column for proper height.