Quote:
Originally Posted by Brett Farley
Morning all, this may be a dumb question but here it goes. I have a post 1995 600 JR Mark V set up for 12 gauge shells. Station 1 (de-priming/case sizing) station does not properly resize brass on the shells. I have looked on line at MEC adjustments as well as following the limited directions in the manual for this station. However, when I check the brass sizing in a MEC Shell Checker the brass is still slightly to large to fit. At first I thought it may be the particular once fired hulls I was using (RST) but I also checked w/Remington STS once fired hulls and I get the same results.
To make sure I wasn’t losing my mind I resized them in a different 600 JR Mark V that I have and they resize properly. Any thing I’m missing or any suggestions would be appreciated. I may end up ordering new parts for this station but wanted to check before I did as this unit is in good condition and has seen little use. Thanks - Brett
|
The resizing ring on a MEC600 is a wear item. They wear faster when reloading hulls with steel heads rather than brass but they do last a long time.
They are gauge specific. It's 20A for 12ga.
https://www.mecoutdoors.com/600-jr-mark-5-parts