View Single Post
Unread 09-20-2009, 09:40 PM   #15
Member
VH20
Forum Associate

Member Info
 
Join Date: Dec 2008
Posts: 131
Thanks: 5
Thanked 49 Times in 26 Posts

Default

OK, here's a quickly-taken, poorly-focused shot comparing the back of the frame to the stock. It makes it apparent where the areas of wood-to-metal contact are (at least the available areas for contact). Keep in mind that much of that metal in the center may not actually be in 100% tight contact if it hasn't been bedded - something to think of when you shoot heavy loads with heavy recoil. On the plus side, this small amount of contact area is huge compared to a lot of sidelocks! The next step will be to clean up all the release agent still stuck to the epoxy, and sand/grind away the flashing where the epoxy has been squeezed out. More later: [IMG][/IMG]
Jim Williams is offline   Reply With Quote