Quote:
Originally Posted by Grayson Williams
Back to square one.Purchased the Parker today 899xx still can't remove the bbls tried all the forum tricks.DH 12 bore original condition never had a screw turned looks like 3 D.barrels condition probably 60 %.Tried all the forum tricks to get the bbls off.What do I need to do if I remove the floor plate.sic working off a note pad.Regards GW
|
What has worked for me (about 50% of the time) is to open the gun as wide as it will go, and remove the cocking hook screw. This won't work on many guns as the gap is not wide enough to remove the screw without galling it, against the water table.
This will allow you to get the barrels separated, but doesn't address the original problem. The gun will need to come apart to clean and properly lube the unhooking pin, crank, cocking slide, etc.