Joe,
nothing really jumps out to me from your pictures, on the third picture where the extractor seems to be fully retracted, it does appear that it could be tweaked upward, it look like there might be some room at the top.
Also, if you remove the barrels and then manually pull the extractor out, does it have any downward movement like your guide pin may be bent?
Meaning that the further the ectractor extends, it keeps dropping lower away from the shell?
There is a set screw that retains the extractor guide rod/pin from fully coming out, this screw can be backed off to allow the extractor to be removed, and then you could check for straigtness of the rod/pin.
Stan
|