That looks good. I checked the dimensions, and it looks to me like 23.5 mm is a little big. All the new cases I have seem to measure about .912 to .914. I am guessing that to get right on, the best plan would be to use a 0.875 (7/8) hole then bore them to the exact dimension. Looked on eBay and found that a common item is a Heim rod fitting for custom suspensions. I ordered a set of two for $15. They are threaded for 7/8 studs inside and are 1-1/4" outside with a 1-1/2" hex flange on one end. Inside bore to .912 and thread the outside to 1-1/4 thread and you have a resizing die. I think I will make 2; one tapered for the first 1/2 inch to make the entry easier and the second straight walled to take the sizing all the way to the rib.
|