Quote:
Originally Posted by edgarspencer
Honestly, I've thought of those devices also. One good thing about them, is that a corded hand drill has more low speed torque than one of the inexpensive mini bench drill presses. You can slow the hand drill down to a desired speed, whereas the mini drill presses only go down to about 800-1000rpm, and don't have the torque when rolling the larger, i.e. 8,10 and even 12ga hulls. A friend bought a mini to roll 10ga and it stalls it or the belt slips (can't remember which he said).
Another good thing about the devices that hold your hand drill aside from the low entry cost, is they take up very little space on the loading bench. In fact, I think I just talked myself into one.
|
I have seen this too about the mini press not having the torque, I watched a video of a guy using one to roll crimp and it would keep stopping the motor or the belt would slip.
The problem I could see with that particular guide is its 3/8"s. My PR roll crimper is 3/8s so when I tried to use it in a hand drill the chuck had no room to actually tighten down on it so it would just spin, having a 1/2" press fixed that though.
My idea was to get one of those guides and attach a old style hand crank drill to it like one of these
https://www.amazon.com/hand-crank-dr...nd+crank+drill seems like you would basically have something that works like a old school roll crimper but vertically and you could change out crimp heads and do any gauge.