Thread
:
Finally set up the drill press for roll crimping
View Single Post
03-06-2022, 10:46 AM
#
32
Member
Keith Doty
PGCA Member
Member Info
Join Date: Dec 2018
Posts: 641
Thanks: 732
Thanked 838 Times in 339 Posts
I'd think a start crimp station would be a must. Doubt you'll be able to get any kind of a consistent quality crimp without one. These are new 3 1/2" Cheditte hulls cut to 2 7/8" then loaded with an OSC under the crimp.
Attached Images
IMG_2578.jpg
(517.4 KB, 1 views)
The Following User Says Thank You to Keith Doty For Your Post:
Keith Sirmans