Thanks Allan. Refer to post #42. McCormack and I had a display at Baltimore a few years ago where 00, 000, and 0000 frame .410s in grades up to A-1 Special as I recall, were displayed. However, I never measured the pin separation until Geoffroy bared a 0000 frame gun for me at Allentown years ago. I had a preproduction BHE .410 in my hands thanks to Repro rep Ray Stone, but I'm not entirely sure that gun had the same pin separation as a production 0000 frame, and anyhow, I didn't measure it. OK, the truth is in courtesy of Allan, 13/16" separation on the 0000 .410.
|