View Single Post
Unread 10-08-2021, 08:58 PM   #7
Member
Milton C Starr
Forum Associate

Member Info
 
Join Date: Jun 2019
Posts: 1,509
Thanks: 476
Thanked 1,009 Times in 466 Posts

Default

Quote:
Originally Posted by Wayne Owens View Post
I believe the Cheddite primers are made from a thinner gauge material and/or the material is more brittle than other brands. Also, your right firing pin might extend past the frame more than the left pin does when fired or the pin might not be rounded as well as your left pin causing the puncture of the primer.
I just read a thread on here from July and it seems numerous members have had the same issue with the Cheddite hull/primers . I havnt seen Federal 10 ga hulls in stock for months . I could always buy steel shot loads to pull apart for hulls but im not that desperate yet . From what ive was reading the main concern with those pierced primers is gas going back into the action and causing stock damage . From what I can tell when I cleaned it earlier the firing pins look pretty well fitted to the holes .
Milton C Starr is offline   Reply With Quote