Nice looking loads hard to improve on them
My take on the job, It has to be square & drill press only way I know to get it right. Actually I use the mill & made a 4 hull fixture. Clamp it in the mills vise and move the table to each hull. All 4 one set up. Mills not necessary just faster production. Sometimes I think about using the quill depth stop, feel on the handle is sufficient.
Small used inexpensive drill press will do the job. Cheap Chinese vise works fine. For a fixture drill hull sized holes in hardwood then split it into a clamshell fixture 3 or 4 hulls. Gap let’s it tighten. vise does not need to be clamped to the presses table. Slide it hull to hull. That’s what I did before going to the mill.
Having said that I fold crimp my short 10s on the PW press until the case mouths fail then cut shorter & roll . Shorter loaded hulls go to 1 oz # 8 loads
William
|