I just ordered a $49.99 quad pin 10 gauge roll crimper off reloaders network from the “loads of bacon” YouTuber. There really only two other currently manufactured roll crimper I could find. A one pin from BPI and a 2 pin from precision reloading. Both for $28, plus shipping, plus tax. So for another $10, or less, I ordered the quad pin roller with zero tax charged and free shipping. Cant wait to try it out.
I cut these hills down and glued the shot cards in place. The cuts aren’t perfectly even. Is there enough hull left to roll crimp my shells below? Do I need to cut them perfectly even to get a good roll crimp? I hot glued the shot cards in place so I would assume it would make a mess. I will probably just shoot these up and start with fresh hulls to roll crimp. Just wondering how much hull I need to leave above the shot card for a proper roll crimp. Cant wait! I’m guessing with using this roll crimper I can load shells that will reliably feed and keep the shot inside my hull while cycling through a semi auto?
