View Single Post
Meriden SxS
Unread 01-15-2011, 12:53 PM   #3
Member
Kirk Pfeffer
Forum Associate

Member Info
 
Join Date: Dec 2010
Posts: 47
Thanks: 3
Thanked 26 Times in 9 Posts

Default Meriden SxS

Hope I'm not drawing this out too long so I appreciate everyone's patience. Questions I have are:
  • I was going to take the sideplate apart to clean it. Is there anything I need to be careful about when disassembling it?
  • I need a firing pin seat which I'll have to try and locate somewhere. Doesn't this also need some kind of a spring for the firing pins?
  • One of the parts on the Numrich site was called a locking bolt. I'm not sure what it is or where it goes but it's a pretty good sized part that I don't see in my gun. Any thoughts? Would it happen to go in the round hole in the receive right in front of the safety rod?

Well this is a start and I'm sure I'll come up with some more questions as I go along.

Thanks again,
Kirk
Kirk Pfeffer is offline   Reply With Quote