[6pt-Sika]

Originally Posted by Mike Koneski

Andy, next time you are here I’ll show you my set up. 650 Jr presses for specialty length shells in 10, 12,16,20,28 and .410 along with a Lee press for black powder and a Spolar progressive for standard length 12,20,28 and .410 if I need volume. I can load anything from large ITX and TSS non-tox right up through #10 and #12 lead. Spreaders in every gauge. I am set up to roll crimp too. If that’s not enough take three steps over and we load metallic cartridges too. 😁😎

Your infection with this disease may be worse than my own

I've not been the Spolar route but I was and still am eaten up with the PW is the Rolls Royce of loaders . Sadly my only PW loader anymore is my main rifle loader .

I kinda did this ass backwards from most folks ! I started with PW 800's then sold them when I quit competing . Later when i wanted to get back into shotgun loading I started buying MEC stuff . A lot was used but some was new it's kinda hard finding a used 9000 in 16 gauge LOL's !