Thread: Cut Barrels?
View Single Post
Unread 07-04-2020, 07:52 PM   #18
Member
Keith Doty
PGCA Member
 
Keith Doty's Avatar

Member Info
 
Join Date: Dec 2018
Posts: 664
Thanks: 771
Thanked 884 Times in 359 Posts

Default

Thomas, I think you've dodged a bullet! I'm no expert, definitely defer to some of these quite knowledgeable gents, but those SURE LOOK suspicious. Wide gap between the barrels and that lump of solder on the left one at the end of the rib? End flat on the rib appears a bit crooked and funny? Doesn't match the "book". RUN is the best advice. Best of luck with your search.
Keith Doty is offline   Reply With Quote