View Single Post
Unread 03-09-2020, 05:30 PM   #40
Member
Craig Budgeon
PGCA Member

Member Info
 
Join Date: Jan 2016
Posts: 508
Thanks: 144
Thanked 388 Times in 225 Posts

Default

Calibrating the Manson/Brownell should be done in a level plane and the 2 points that establish that plane are the anvil ( the measuring point inside the barrel) and the point where the tool is held during use. After the measurements have been taken I check the calibration again to verify that the measurements I have taken are accurate. While i take the wall thickness measurements I repeat the measurement in each position to verify accuracy. Edgar, the pictures of your work area remind me of home on intense days.
Craig Budgeon is offline   Reply With Quote