The physical mounting of the triggers is the same on both single and double trigger plates. The mounting of the trigger spring is simply a matter of drilling and tapping a 2-64 hole in the proper place, which I have already done.
I welded up and dressed down the single trigger milling in that area on the back side but have left the milling in the forward areas. No real need to do anything there since it will not be seen and does not effect function of anything.
This particular gun is getting restocked, so the safety mechanism is of no concern. A DT jacket toggle will be inletted into the new stock in the typical fashion.
__________________
B. Dudley
|