[Bibb Gault]

Chuck,Dean and Dave.
Rear of extractor is stamped 514, so it must have been ordered that way. My pic is misleading because it was shot off axis. I believe the extractor had damage from hitting the firing pins at some point and that they are not "notched". The marks/notches are very un uniform. The rib sides do not show any Damascus pattern.

I am wondering if the other Parkers that labeled as "parts guns" were in fact purchased for that.

1st. gun... 20ga #85642 P grade,0 frame. 28" twist barrels with extractor. Gun is functional, but missing stock/butt and a piece of internal linkage for the safety. All numbers match. Can a stock and safety linkage be had for this gun so it can be made shot again without breaking the bank? Gun has minor surface rust, but the barrel bores look spotless.

2nd. gun... 20 ga Trojan. 178175, 28" Trojan Steel barrels,extractor . Gun is complete and functional except for catastrophic failure of the right barrel. How hard is it/costly to fit a set of used barrels at make this a user again?

Thanks, I notice this forum has some sort of system for thanking members. How does this work?
Bibb