View Single Post
Unread 11-11-2017, 12:14 AM   #33
Member
Heff
PGCA Member
 
Chad Hefflinger's Avatar

Member Info
 
Join Date: Nov 2014
Posts: 302
Thanks: 608
Thanked 582 Times in 124 Posts

Default

Ok, now I'm confused. The load I referenced, 1 1/8 @ 3 dre is what was referenced in an earlier post as recommended service load. The only difference in my question was about using this same load in a shell that is 3/8" longer than the actual chamber length. This is basically what we were discussing with using a 2 3/4" shell in a 2 3/8" chamber. Why would one far exceed the published service load and one be much ado about nothing? I'm not busting anyone's chops here, I'm just trying to understand
__________________
"There are two kinds of hunting: ordinary hunting, and ruffed grouse hunting"-Aldo Leopold
Chad Hefflinger is offline   Reply With Quote