View Single Post
Fore End Iron
Unread 08-08-2010, 11:16 AM   #11
Member
Austin W Hogan
PGCA Invincible
Life Member

Member Info
 
Join Date: Jun 2009
Posts: 676
Thanks: 0
Thanked 408 Times in 197 Posts

Default Fore End Iron

The tip of the fore end has a large screw head showing in the photo, indicating that the proper extended fore end iron or loup was installed at the time the BTFE was fitted. This required heating the barrel asembly, removing the old piece and soldering in the new. It was apparently not a difficult job if the proper jigs were available. There are many early guns around with BTFE and/or ejectors retrofitted. I will post a picture of the part when I have a chance.
The info about Runge is from an article by Remington's last master engraver in the Remington Society newsletter a few years ago.

Best, Austin
Austin W Hogan is offline   Reply With Quote