View Single Post
Unread 02-25-2017, 04:37 PM   #45
Member
Quack me up!
PGCA Member

Member Info
 
Join Date: Dec 2008
Posts: 162
Thanks: 235
Thanked 99 Times in 35 Posts

Default

I received the above mentioned gun today. I tried to check the bore diameter with my Skeets gauge but it doesn't appear to go large enough. Did they make a gauge specifically for the 10 gauge? The instruction sheet gives a nominal bore dia. of .775 for a 10ga. The gauge went up to about .782 but it would still rattle around inside the bore so I couldn't get an accurate reading. The constriction on each barrel was about .765
Do you think that since the gun was ordered to shoot extra close that it would have had a larger than normal bore diameter for some reason??
Bob Dombeck is offline   Reply With Quote