Thread: Wondering ?????
View Single Post
Unread 08-16-2016, 02:10 PM   #59
Member
Drew Hause
Forum Associate
 
Drew Hause's Avatar

Member Info
 
Join Date: Nov 2008
Posts: 2,269
Thanks: 371
Thanked 4,272 Times in 1,387 Posts

Default

Thanks again Rich. Please also confirm the chamber length and bore measurements just proximal to the bulges.

The issue is not to dispute Steve's statement, nor to assign blame, but to reach some conclusion as to the cause of the barrel failure.

It is my sincere hope that this will not end as most posts regarding barrel/gun failures, at least on doublegunBBS and trapshooters.com, have ended; with no definitive, or at least learned, explanation. Modern guns sent to the maker for a failure analysis and metallurgical study disappear, and when litigation is involved, details of any settlement are made confidential.

Something like this would be definitive



To be clear, I have found no Specification Diagram for wall thickness from any turn-of-the-century U.S. maker. That information would be invaluable to those of us measuring wall thickness and providing an opinion regarding originality, and safety.

Last edited by Drew Hause; 08-16-2016 at 02:41 PM..
Drew Hause is offline   Reply With Quote
Visit Drew Hause's homepage!