View Single Post
Unread 06-20-2016, 01:01 PM   #5
Member
Bill Murphy
PGCA Lifetime
Member Since
Second Grade

Member Info
 
Join Date: Jun 2009
Posts: 16,551
Thanks: 6,770
Thanked 9,902 Times in 5,257 Posts

Default

Put fired shells in the chambers and measure to the center of the primers. This is the "non machinist's" method of measuring firing pin distance by just using the barrels. 1 1/2 and 2 frame firing pin separations are the same, but other measurements are different. Refer to The Parker Story, page 527, if I remember correctly.
Bill Murphy is offline   Reply With Quote
The Following User Says Thank You to Bill Murphy For Your Post: