L C Smith
If you take out the screw the connects the side plates and screw it in the right hand lock it gives some leverage to move the plate forward and up at the same time. This helps tremendously in preventing chips at the rear of the lock. Go around the lock with a very sharp blade to cut old crud/ finish that might have "glued" the plate in. The other side can usually be coaxed out using a pin punch after cutting around it. This is usually done with the locks cocked. If you are trying to cock it and the seers won't catch, try putting forward pressure on the triggers while you are trying to cock it. Sometimes built up crud can prevent them from catching.
|