I also use a table saw for both paper and plastic. Here's how simple it is. Take a two foot long section of 2X4 and trim it so that it is 2 inches wide. Measure the diameter of the gauge you would like to trim. Drill holes through the 2X4 of that diameter ( I have 10 holes in mine so I can trim 10 hulls at a time ). Insert the hulls through the 2X4 and adjust your rip bar to the length of hull you want, then run the 2X4 with the shells in it very slowly thru the blade. Use a blade with very fine teeth for the smoothest cut.
|