View Single Post
Unread 12-01-2015, 05:45 PM   #17
Member
BRDHNTR
PGCA Lifetime
Member

Member Info
 
Join Date: Nov 2012
Posts: 4,034
Thanks: 8,589
Thanked 3,058 Times in 1,381 Posts

Default

Gents, perhaps I was not fully clear in describing the problem. When it malfunctions, the gun is broken open, the shells are ejected but I am unable to close the gun. The gun locks in the open position I then remove the fore end, then I'm able to remove the barrels from the frame. I pull out the ejector rods (?) then I put the fore end back on the barrels and push the rods back in each to cock the ejector hammers. I then remove the fore end and mount the barrels back on the frame, re-attach the fore end and I'm good to go until this happens again. Twice thus far. I walked Dan Cullity through this process and hopeful he can figure it out. I only reload and shoot Remington Gun Club shells w/ 1 oz loads.
allen newell is offline   Reply With Quote
The Following User Says Thank You to allen newell For Your Post: