Steve,
I have the same problem with a DH 10 gauge except my hinge pin was about 10 o'clock rather than 9. I think Austin had one that he was able to tighten with a screw driver made to fit the whole slot chucked into a drill press. Don't do this until it is confirmed by others. The hing pin is pressed into the frame and I would think it would have to be pressed out and reinserted to get the screw to index. Don't tell the rest of the guy's here but, I took the hing pin screw out of my DH and shimmed it with enough brass sheeting to make it index.
Harry
Last edited by Harry Collins; 03-27-2010 at 10:09 PM..
|