Early on I perchased a repro close-out from Jaquas. It was my first Parker gun and had the SST. I have hunted with SXS with DT and also pumps,autoes and over unders. I do not have any problem knowing the operation of the trigger types when hunting. The problem with the repro's SST is its to hard to change at moments notice in hunting situations. I may still buy one of them hard to find 12ga. models that I can't find with DT and drill a small hole in that switch and install a small roll pin. This would give me something to get hold of to move it quickly. Would also go inside and find out why its so hard to move? If this issue could be fixed I would not mind the SST feature. Its a good trigger system that works...it does have to be kept clean and free of dried up oil. 99% of doubleing is due to gumed up trigger parts. Its not easy to get inside a repro...them trigger plate screws can be very tight and froze. Only perfectly fitted screw driver tips hand made to fit each screw if necessary and a very carfull hand! Thanks all SXS ohio...(-:
|