Quote:
Originally Posted by Dean Romig
The lightening cuts on the 0-Frame lifter consist of one cut per side with a length of 1.92" each and a width of .38" wide each and a depth of .112" for the cut on the left water table and .102" for the cut on the right water table.
As a comparison, the lightening cuts on an 0-Frame T/A consisting of two cuts per flat are 1.37" in length each for the cuts to the rear of the check hook rod and .89" for the forward cuts. The width of these cuts are .37" wide and .102" deep.
Okay fellas, get out your slide-rules and figure the ounces saved on the lifter and the ounces saved on the T/A....... Ready - Get set - GO!!
|
I can't help you unless you give me the radius at the bottom of the slots.
