View Single Post
Unread 09-30-2013, 07:15 AM   #1
Member
Mark Garrett
PGCA Member

Member Info
 
Join Date: Jul 2013
Posts: 380
Thanks: 2,616
Thanked 204 Times in 111 Posts

Default

If your loader has the short taper die you should be able to pull it out of the loader once the components are loaded and roll crimp , them place it back in and push the loaded round out ( maybe ) not sure if PW will push a roll crimped shell out without messing up the crimp , as they designed for fold crimping . It is worth a try , although it will be a slow process .

Or you can , as suggested before , resize with supersizer to the point where the hull will slide in the die freely , ad your components and slide the hull out by hand and roll crimp.

Or , as roll crimping does not reduce pressure enough to worry about , you could find a load that will fit with a fold crimp at the pressure you want and go that way , probably your best option .

Hope this helps

Mark
Mark Garrett is offline   Reply With Quote