Checkering color
 

I am but an amateur, so please forgive me if I am asking silly questions. I have now recut the checkering on several of my low grade utilitarian Parker’s and while the quality of the job seems acceptable I just can’t get that same original color out of it. Original Parker’s seem to have darker colored checkering compare to the rest of the finish than what I have recut and then brushed finish into. Is there some special finish or is that abstract color just an artifact of age?

Thanks

I believe that Brian Dudley recommended in a different thread, using shoe polish to simulate the "gunk" that accumulates in the checkering over time.

Yep that was my thread. Those dots just connected for me. Little slow on that one. Thanks

I had an 1893 Grade-1 16 gauge TA hammer gun that was all original in every single respect. It was the closest to ‘mint’ condition that most of us have ever witnessed… It is my opinion that the darker checkering is due to oil, grime and whatever getting into the grain of the checkered wood, even on seldom used guns, but used nevertheless.
This one has never been in the field or fired to the best of our collective knowledge.
Judge for yourselves.

.

Thanks for posting that one Dean. That's a real treasure and hard to imagine that it hardly ever, or never got used. You said you HAD, did you sell it?

Yes, I sold it in 2013 when I was “downsized” and still had a mortgage. I sold it and another Parker and paid off my mortgage. It would have been foolhardy to have done otherwise.






.

When recutting old original checkering, if the recut checkering is not darkened by some means, it will always end up looking lighter than the stock and will absolutely SCREAM that it has been recut. If anything the stock overall has been darkened with age to where even though both are natural wood, the fresh cut wood will be lighter, even with just oiling.

You can daken the recut checkering with a little shoe polish.