![]() |
Springs
Is there a source for firing pin return springs for a lifter? If not original style. can an off the shelf substitute be used? I need 2 for a 10 ga I bought.
|
You might try Brian Dudley.
|
The Home Depot. They’re pretty generic. They’re not especially strong.
. |
There is not anything too special about them. Anything can be substituted in. They are about 1/4” diameter and maybe 3/8” long. And relatively light.
|
Thanks everubody. I'll see what I can come up with. I know the ones in my other lifter were reduced on each end, but I wondered when I took them out if that was necessary. It looks like both ends set on a flat.
|
All times are GMT -4. The time now is 02:56 PM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Parkerguns.org