Barrel steels
 

Perhaps a multi asked question but can someone (without getting to technical) explain the difference in the steels (as labeled on the top flat of the barrel rib) used for barrels on Parker guns ? Perhaps strongest to weakest but not Damascus.

There seem to be several names so I wonder about their strengths. Especially if barrels have been honed/polished to about .030 MWT in the tubes with higher thickness at the front of the forcing cone and then tapering down to the .030 measurement.

Thanks in advance.

That subject has been visited several times over the years on this forum. Without revisiting all the details and data on the topic may I suggest using the search function in order to access those very informative discussions.

Incidentally, .030” in the forward half of the tubes is sufficient for safe shooting, of course tapering thicker to the forcing cones.





.

Not really Harry - as time progressed the barrel steel compositions changed and when Remington started making barrels for the Parkers it changed a bit more radically with the 'new' chromium molybdenum steel.

Not to say they weren't so close that the average person could tell them apart.





.

I thought that Dave Suponski studied this subject a while back.

As Dean said, a recent discussion
http://parkerguns.org/forums/showthread.php?t=32925

For the long version
https://docs.google.com/document/d/1...EK8OtPYVA/edit

Pre - WWI Parker “Titanic” barrel (courtesy of Dave Suponski) - AISI 1030 with low concentrations of nickel and chromium.
Pre - WWI Parker “Trojan” barrel (courtesy of Dave Suponski) - AISI 1035.
Pre - WWI Parker “Vulcan” (courtesy of Ron Graham) - AISI 1015.
Post-WWI Parker “Vulcan” barrel (courtesy of Dave Suponski) was AISI 1030.
“Parker Steel” was non-standard Acid Bessemer Resulphurized Rephosphorized AISI 1109 low carbon Steel.

None of those barrels were tensile tested.
The industrial standard for 1030 is 68,000 - 78,000 psi; but I recently tested an Acier Cockerill 1030 that was 90,000 psi
https://www.doublegunshop.com/forums...&Number=599972

So cut me a chunk of Whitworth or Acme steel and I'll have it tested ;)

OK.... Thanks all who replied.

The gun I am looking at has "Special Steel" barrels. Am I correct in thinking this was the final steel of note used on Parkers and... given good measurements with a MWT of .030 can be shot with moderate pressure modern loads ?

Parker Special Steel was used on G grade or grade 2 hammerless Huns and with good wall thickness and structural integrity, can be shot with moderate modern loads b

Thanks Jim....

From my collection of barrel flat pictures the early fluid steel guns only sported two different barrel steel marks -- Kf on the flats of Vulcan Steel barrels --

Attachment 98328

and K on the flats of barrels rib marked both Titanic & Acme --

Attachment 98327

In the mid 13xxxx range I see the transition to the letter(s) in a circle markings -- V, P, P.S., T or A.