Seeking parts.
 

I'm partially restoring the two 12ga SxS's I inherited from my pop and am seeking a source of parts, either originals or reproductions.

I am familiar with and in contact with Brian Dudley and there are certain parts he is currently out of so I'm seeking other sources as well.

I was formerly advised that Parker gunsmiths are good sources, but other then Brian I don't know any.

I'd appreciate some suggestions from the crowd.

Thanks in advance.

If all else fails you might contact Joe Breda by PM on this forum. He can duplicate many small parts with a process he calls reverse engineering.





.

Some of we members have parts. Tell us what you need.

It's for my GHE 12ga SxS.
I need the little flat spring that keeps tension on the forearm release lever. It broke as I was disassembling the forearm to refinish.

It's about 30mm long x 3-6mm wide x 1mm thick. It has a screw hole on the 6mm end and tapers to 3mm.

Photo attached.

Roberto, I’ll be back in NJ Monday evening and I’ll PM you. I can help you out. Jim

Hey gang===Tony ---Connecticut Shotgun Mfg. is licensed to MAKE Parker Shotguns & has ALL the PARTS to do same, of which I have seen.

Allan

I have remanufactured Parker Ejector Hammers and are now available. Please give me a call or email if Ejector Hammers are needed.
Joe Breda
661-902-1602
Blackjackcash2@cs.com

I have safety lever and jacket units for $ 75.