Parker Gun Collectors Association Forums

Parker Gun Collectors Association Forums (https://parkerguns.org/forums/index.php)

- Parker Restoration (https://parkerguns.org/forums/forumdisplay.php?f=8)

- - Setting shield brads (https://parkerguns.org/forums/showthread.php?t=24162)

Bill Graham

05-04-2018 09:04 PM

Setting shield brads

1 Attachment(s)

Is it ok to set shield brads that are too proud?

Brian Dudley

05-04-2018 09:17 PM

Your shield is proud too.

It is best to re-inlet, epoxy it in, install the brads and dress it off before refinishing.

Bill Graham

05-04-2018 09:42 PM

Quote:

Originally Posted by Brian Dudley (Post 242952)

Your shield is proud too.

It is best to re-inlet, epoxy it in, install the brads and dress it off before refinishing.

Haven’t done that before, but I have a set of tiny carving chisels I can try.

Bill Graham

05-05-2018 12:16 AM

Got it. Simple enough. Thanks Brian.

Mike Franzen

05-05-2018 06:55 AM

Let’s see a pic of how it turned out Bill.

Brian Dudley

05-05-2018 08:55 AM

Most times it is corrosion from the backside of the shield that pushes it up off the wood. Taking it iff and cleaning that crud out is usually enough to get it reset nicely.

Bill Graham

05-05-2018 11:51 AM

1 Attachment(s)

A lot of blue/green crud, but needed a little more help.

Brian Dudley

05-05-2018 01:49 PM

Looks good.

Sure they did not have epoxy in the day, but i situations like this, it is best to improve upon their methods where we can.

Mike Franzen

05-09-2018 07:20 PM

Looks really good Bill. Nice work!

All times are GMT -4. The time now is 06:33 PM.