Skeleton butt-plate removal
 

Any tips for a fella’ who must remove a Skeleton Butt-Plate from a Parker Reproduction? :banghead:

Not worried about the screws. My concern, is taking a pc of the checkering with it by chipping a pc out. I would like it a lot if that didn’t happen. Maybe tape the checkering about the perimeter of the plate, tap the plate to separate it and then carefully ease it off straight as possible, evenly?

All advice appreciated!

The checkered panel, if stuck to the butt plate, will probably come off with the butt plate.





.

I knew the checkered portion was an insert / separate from the actual stock but, I would have guessed it was at least glued to the rear of the stock. Thanks for the tip, Dean. That certainly puts a different perspective on removing the plate. Unfortunately, even if the wooden checkered insert is likely to separate, intact with the plate - I still 'may' have to separate the two so I can perform a repair. :cuss:

*Were original Parkers with SBP's constructed that way as well? (an insert?)

No. Meriden (and remington) inletted them fully into the butt.

The insert may stay glued to the butt, but in my experience, it will likely come off attached to the plate. No big deal either way.

A quick swipe with a small, sharp chisel across the top of the wooden insert. (to cut through the glue overflow) Followed by a delrin, chisel-shaped spatula I whipped up in about 8 seconds helped me to separate the plate from the butt, insert intact, nicely.

Thanks guys, I would have gone after differently without your help.

There are lots of details about Parker construction that I don't know about and this is another one. Interesting that for repros, the checkered section is an insert separate from the stock. So they would fit the SKB to the stock so the outside edges are flush, including the spur, and then fill the center space by fitting a checkered insert into it? While I am not a stockmaker, it seems that fitting this insert would be more trouble than just inletting the SKB to the stock? I guess you have the advantage of not having to checker end-grain?

The stocks were hollowed out under the glued on insert.

Believe me, it is way harder to fit an SSBP the way Meriden did it than the way Winchester Japan did it.

Exactly what I discovered, once the plate was removed- my summation was that this was to achieve balance, yes?

Yeah,you drove a straight nail there...a separate insert is the easy way out for sure, but not the traditionally done ...that being said it do have the benefits of nicely hiding a drilled stock ( for balance )
or even getting a last little bit of lop out of a short blank

I believe you, and thanks for the knowledge.