16 Gauge Load Verification
Hello, everybody! It has been a long time since I visited the site. I hope you all are doing well.
I found this load some time ago. I do not recall exactly where or when, but, I was hoping someone might recognize it. Here it is, verbatim: "Ched’s 2 1/2” hull & 209 primer. 3/4 oz load in a SG16 with 18.8 gr of Longshot. 1138 fps & 4733 psi. It comes from the low pressure group data and carries a note from Tom Armbrust, “Very consistent”. That’s been my experience with it as well." If anyone has tried this load, I would like to hear about their experience. Cheerio! |
I have no experience with that load but if I can find the components I'm definitely going to try it! Sounds perfect for my PH 16 with twist barrels. Thanks for posting the load data!
|
It is nearly identical, with the exception of powder, to my 7625 load, and I have been told that when I run out of 7625, I should use Longshot. Others have suggested Universal. As an exercise, I may try both, but I have a pretty good supply of IMR powders
|
Hey Edgar, you get a chance,what is that load with 7625, I still have 3+ pounds of it.
Been using International for my 3/4 oz 16 ga loads with a DR16 wad , but into my last pound of International. |
Winchester 572 might be another viable powder for a low pressure 3/4 oz load.
|
Quote:
2 1/2" Cheddite, WIN 209 18.5gr 7625 SG16 7/8oz #8 6pt fold crimp |
Same load that I make Edgar. A very nice loading.
. |
All times are GMT -4. The time now is 12:53 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2024, Parkerguns.org